To Stop The Product; To Switch Off The Product; To Charge The Battery; To Adjust The Cutting Height With Automower Access - Husqvarna AUTOMOWER 435X AWD Operator's Manual

4.2.3.2 Park for a selected number of hours
The product goes to the charging station where it stays
for a selected number of hours, then it automatically
goes to the usual operation that is set in the
settings. This operation selection is applicable when it is
necessary to pause operation, for example for
temporary irrigation or work on the lawn.

4.3 To stop the product

1. Push the STOP button on top of the product.
The product stops and the cutting motor stops.

4.4 To switch off the product

1. Push the STOP button to stop the product.
2. Enter the PIN code if required.
3. Push the jog wheel for 3 seconds to switch off the
product.
4. Make sure that the LED status indicator is not lit.
Note:
If the LED status indicator is lit or is
flashing in any color the product is not switched off.
LED status indicator on page 13 .
Refer to
1404 - 006 - 05.01.2021
Note:
it stands in the charging station.
Schedule
WARNING:
switched off before any maintenance is
done, or if the product must be moved from
the work area.

4.5 To charge the battery

When the product is new or has been in storage for a
long period, the battery can be empty, charge the
battery before you start the product. In the
mode, the product automatically changes between
mowing and charging.
WARNING:
with a charging station and a power supply
which the product is intended for. Incorrect
use may result in electric shock, overheating
or leakage of corrosive liquid from the
battery.
In the event of leakage of electrolyte, flush
with water and seek medical help if it comes
in contact with the eyes and etc.
1. Put the product in the charging station.
2. Put the product in as far as possible and make
sure it is connected to the charging station.
The battery status can be monitored on the status bar of
the display.
Note:
If the battery is empty the product needs to
charge for a longer time period before the product is
possible to start.
4.6 To adjust the cutting height with
Automower
The cutting height can be varied from MIN (3 cm / 1.2
in.) to MAX (7 cm / 2.8 in.).
Note:
During the first weeks after a new installation,
the cutting height must be set to MAX to avoid damaging
the loop wire. After this, the cutting height can be
lowered step by step every week until the desired cutting
height has been reached.
1. Push the STOP button to stop the product.
The product cannot be switched off when
The product must be
Main area
Only charge the product
®
Access
Operation - 35