Husqvarna AUTOMOWER 435X AWD Operator's Manual page 17

CAUTION:
Do not lift the product when
it is parked in the charging station. It can
damage the charging station and/or the
product. Push the STOP button and pull the
product out of the charging station before
lifting it.
To safely move from or within the work area:
1. Push the STOP button to stop the product.
2. Enter the PIN code if required.
3. Push the jog wheel for 3 seconds to switch off the
product.
4. Make sure that the LED status indicator is not lit.
5. Carry the product by the lifting handle as the
illustration shows.
1404 - 006 - 05.01.2021
2.3.4 Maintenance
WARNING:
switched off before it is turned upside down
and before any maintenance is done.
CAUTION:
Do not use a high-pressure
washer or even running water to clean the
product. Do not use solvents for cleaning.
WARNING:
the charging station before any cleaning or
maintenance of the charging station or the
loop wire.
Inspect the product each week and replace any
damaged or worn parts. Refer to
37 .
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical components
in the product and the charging station, we recommend
that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wire) if there is a risk of a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked AR, AL
and G1, G2.
2. Disconnect all connected wires and the power
supply.
3. Connect all the wires and the power supply if there
is no longer a risk of thunder. It is important that
each wire is connected to the right place.
The product must be
Use the plug to disconnect
Maintenance on page
Safety - 17