Husqvarna AUTOMOWER 435X AWD Operator's Manual page 54

between AL and the point where the guide wire is
connected to the boundary wire (thick black line in
the illustration).
AL
GUIDE
Guide
To rectify the fault you will need boundary wire,
connector(s) and coupler(s):
a) If the suspected boundary wire is short then it is
easiest to exchange all of the boundary wire
between AL and the point where the guide wire is
connected to the boundary wire (thick black line).
b) If the suspected boundary wire is long (thick
black line) then do as follows: Put AL and G1 back
to their original positions. Then disconnect AR.
Connect a new loop wire to AR. Connect the other
end of this new loop wire at the middle of the
suspected wire section.
54 - Troubleshooting
AR
If the indicator lamp now is green, then the break is
somewhere in the wire between the disconnected
end to the point where the new wire is connected
(thick black line below). In that case, move the
connection for the new wire closer to the
disconnected end (roughly at the middle of the
suspected wire section) and check again if the
indicator lamp is green.
1404 - 006 - 05.01.2021