Maintenance; Troubleshooting - eta PRETO Instructions For Use Manual

Storing accessories
Accessories (crevice nozzle and brush) put into openable cover A2 (Fig. 19). The accessories,
the floor nozzle, the suction tubes and the hose can be dismantled again or left assembled
and hung on the back side or on the bottom of the vacuum cleaner into the storage position.
For better stability, slide individual parts of the tube to each other so that the tube is as short
as possible. When storing, always set the floor nozzle to the carpet position (i.e. with the brush
retracted); thus you will prevent bending of the bristles.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace,
stove, heating element) and protect it from weather conditions (e.g. rain, sunshine).
Treat surface of the appliance with a soft and damp cloth, do not use coarse and
aggressive detergents! Store the appliance properly cleaned at a dry, dust-free place
out of reach of children and incapacitated people.
Floor nozzle, parquet nozzle, brush
After any vacuuming it is recommended to check visually the brushes or collectors
for possible impurities. If there are some impurities, remove them.
TURBO nozzle (pic. 20)
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If you find some impurities, remove them in the way specified below.
Cut threads and hair with scissors and remove them. If hair or threads are twisted around the
mounting of the drive shaft and if they cannot be removed in the way described above, the
impurities have to be removed by dismantling the nozzles. Unscrew the bolts in the lower part
and remove the cover „
opposite direction (you will hear a snapping sound) and secure it properly with the bolts „
VI. TROUBLESHOOTING
Problem
Motor won't start
Lid cannot be
closed - safety
lock activated
Suction output is
not sufficient
„. Now you can the brush clean it. Insert the lid to the nozzle in the
Cause
Power supply not connected
button is not switched on
Dust filter inserted incorrectly in
the holder
Holder inserted incorrectly
in the suction space of the
vacuum
Regulation in MIN position
Open suction
Dust filter full
Clogged micro-filters
Nozzle, suction hose or tube is
clogged
Check the cord, plug and the socket
Push button
Check / repair fastening of the
cardboard front in the holder
Check/repair insertion of the holder
in the suction space of the vacuum
cleaner
Set regulation to MAX.
Close the hole in the hose handle
Replace the filter
Clean or replace the micro-filters
Remove blocking objects
25 / 41
GB
Solution
„.