Use Of Vacuum Cleaner - eta PRETO Instructions For Use Manual

– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin
in the direction of the arrow and pull out or push in the required length of the tube (Fig. 5).
When you release the lock projection, the tube length is fixed. When pulling out, keep the
tube in safe distance from your face as the tube is very long.
Floor nozzle / TURBO nozzle / Parquet brush
– Connect and disconnect the accessories (B1, B7, B8) in the same way as the tube (Fig. 2).
Floor / crevice nozzle / brush
– Connect and disconnect the accessories (B4, B5, B6) in the same way as the tube (Fig. 3).
You can connect the appliance directly to the hose handle or to the telescopic tube.
– If the rotation brush is blocked during operation (e.g. due to sucking in large foreign
objects, due to winding carpet piles, threads or hair on them etc.) turn off the vacuum
cleaner by switch A4. Then remove the cause of blocking or clean the rotation brush
if necessary (see par. V. MAINTENANCE).
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket.
Assemble the vacuum cleaner accessories B1, B2, B3 (Fig. 2, 3, 4). If the cleaner is
fitted with telescopic tube B3, adjust its length to fit your figure (Fig. 5). Floor nozzle B1 is
designed to be used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is fitted
with a brush, pull it out by switching over a flap when vacuuming hard floorings. You can use
crevice nozzle B6 for vacuuming places that are hard to access (Fig. 7). Upholstery nozzle
B4 or brush B5 can be used to clean various types of furniture (Fig. 8, 9). The vacuum
cleaner can be switched on or off by pushing button A4 marked with the symbol
10). The suction power can be adjusted with the control on hose handle B2 (Fig. 11) or by
setting regulation A6 (Fig. 10). The minimum suction power is recommended for fine fabrics
(e.g. curtains, drapes). The maximum suction power is recommended for floor coverings
(e.g. heavy-duty carpets). After finishing work, switch off the vacuum cleaner and unplug it
from the power supply. By switching button A5 with symbol
be wound automatically. The vacuum cleaner can be held and carried by handle A9.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 (Fig. 12) while the floor
nozzle is lifted above the cleaned surface at the maximum suction power, the dust filter
must be replaced. Disregard changes on the indicator during vacuuming.
Dust filter replacement
Lift off vacuum cleaner lid A3 by pushing lock A2 to the locked position (Fig. 13). Pull out
the dust filter lock A15 from the guide ribs of the holder A14 (Fig. 14) and dispose it with
common municipal waste. Slide the front part of the dust filter (in the direction of the arrow)
to holder A14 in the suction space of the vacuum cleaner and push it to the maximum
position.
ATTENTION
23 / 41
(Fig. 10) the power cord will
GB
!
(Fig.