Chapter 3 Installation; Installation; Panel Pc 2100 - Installation - B&R Industries Panel PC 2100 User Manual

Chapter 3 • Installation

1 Installation

Danger!
• All supplied power must be disconnected before removing device covers or components or
installing/removing accessories, hardware or cables.
• The power cable must be disconnected from the device and from the voltage supply.
• All covers, components, accessories, hardware and cables must be installed or connected be-
fore the device can be connected to the power supply and turned on.

1.1 Panel PC 2100 - Installation

The Panel PC is installed on a swing arm system using an integrated flange.
Installation notes
• Environmental conditions must be taken into consideration.
• This device is only certified for operation in enclosed rooms.
• This device must not be subjected to direct sunlight.
• This device must be installed using one of the approved mounting orientations.
• The swing arm system must be able to hold four times the total weight of the device.
• The flex radius of connected cables (DVI, SDL, USB, etc.) must not be exceeded.
• This device should be mounted in a position that minimizes glare on the screen.
• This device should be mounted in a position and orientation that make viewing as easy as possible for
the operator.
Information:
Before installing the Panel PC on a swing arm system, ensure that the sealing ring is installed on the
PPC2100 swing arm device's flange.
The swing arm shaft must have an outer diameter of 47.5 to 48.4. The end of the swing arm shaft that
connects with the flange must be beveled at a 45° angle and deburred.
Panel PC 2100 swing arm user's manual V1.00
Installation • Installation
83