Table of Contents
Advertisement
3.4
Installing System Software
Copying Software
to the Hard Disk
3-6
Loading System Software
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To install a working copy of the ATM backplane driver and other software
that is supplied with the 386/ATM, run the
diskette installed. Follow the steps shown in Figure 3-4.
NOTE: If you are setting up your system to run CVU10000 software on the
386/ATM, you must perform this procedure after installing CVU software.
Refer to your CVU manual for details.
1. Insert driver disk.
Figure 3-4 Software Copy Procedure
After approximately 90 seconds, you receive the "Installations complete"
message.
program with the
INSTALL
2. At the prompt, type:
A:>
INSTALL
Enter
3. For standard DOS
installation type:
A:>
INSTALL DOS
Enter
4. Or, for CVU10000
installation, type:
A:>
INSTALL CVU
Enter
5. Press any key to
continue, or Ctrl C to
abort installation.
386/ATM Coprocessor User Manual
Advertisement
Table of Contents
