Advertisement
SureCross DX70 Wireless Point-to-Point Kits
** Taiwan - Taiwan is certified to operate specific DX80 and DX99 models. For a list of specific models, refer to the certificate.
Additional Statements - 900 MHz
This device has been designed to operate with the antennas listed on Banner Engineering's website and having a maximum gain of 9
dBm. Antennas not included in this list or having a gain greater that 9 dBm are strictly prohibited for use with this device. The required
antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen such that the equivalent isotropi-
cally radiated power (EIRP) is not more than that permitted for successful communication.
Transmit Power Levels
The SureCross wireless products were certified for use in these countries using the standard antenna that ships with the product. When
using other antennas, verify you are not exceeding the transmit power levels allowed by local governing agencies.
Specifications
Radio
Range
900 MHz: Up to 4.8 kilometers (3 miles) *
2.4 GHz: Up to 3.2 kilometers (2 miles) *
Transmit Power
900 MHz: 21 dBm conducted
2.4 GHz: 18 dBm conducted, less than or equal to 20
dBm EIRP
900 MHz Compliance (150 mW Radios)
FCC ID TGUDX80 - This device complies with FCC
Part 15, Subpart C, 15.247
IC: 7044A-DX8009
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with
FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1
(2006-05)
IC: 7044A-DX8024
General
Power*
Requirements: +10 to 30V dc (For European applica-
tions: +10 to 24V dc, ± 10%). (See UL section below
for any applicable UL specifications)
Consumption: Less than 1.4 W (60 mA) at 24V dc
Housing
Polycarbonate
Weight: 0.26 kg (0.57 lbs)
Mounting: #10 or M5 (M5 hardware included)
Max. Tightening Torque: 0.56 N·m (5 in·lbf)
Inputs
Discrete Inputs
Rating: 3 mA max current at 30V dc
Sample Rate: 62.5 milliseconds
P/N 133214 rev. H
Spread Spectrum Technology
FHSS (Frequency Hopping Spread Spectrum)
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 in·lbf)
Link Timeout
1 or 4 seconds
* With the standard 2 dB antenna. High-gain antennas are availa-
ble, but the range depends on the environment and line of sight.
To determine the range of your wireless network, perform a Site
Survey.
Interface
Indicators: Red/Green Power LED, Red/Yellow Signal
LED
Wiring Access
Two 1/2-inch NPT
* For European applications, power the DX80 from a Limited Pow-
er Source as defined in EN 60950-1.
Analog Inputs
Rating: 24 mA
Sample Rate: 62.5 milliseconds
www.bannerengineering.com - tel: 763-544-3164
27
Advertisement
