Secabo TB7 Operating Manual page 9

store value. If no input occurs for 5 seconds, input mode ends automatically. Pressing
will exit the input mode, the display will return to its original value.
Configuring pre-pressing: (irrelevant for the TB7, time is controlled by the heat press)
Briefly pressing activates pre-pressing for the following press operation using
the preset time, and is deactivated again upon completing the press operation. When
activated, the Time+Pre symbol will light up in the lower part of the display with the
corresponding time indicator. This will count down to 0 while pressing, whereupon the
symbol and time switched off again.
Holding activates the setting mode for the PRE time analog with time setting:
Symbol in the display flashes. Turning the rotary knob clockwise increases time,
counter-clockwise decreases. Press the rotary knob or press to store value. If
no input occurs for 10s, input mode ends automatically. Pressing will exit the
input mode, the display will return to its original value.
Pre-pressing can be activated permanently from the settings menu. More information
below.
Saving to and loading from memory slots: (irrelevant for the TB7, time is controlled by
theheat press)
Press and hold rotary knob in the default state. flashes. The number corresponding
with the memory slot is shown below the disk. This indicator rises by one when turning the
rotary knob clockwise. Each stored temperature value and time / PRE time value is also
displayed at the top. If memory slot is blank, dashes are displayed for temperature and
time / PRE time.
To retrieve a stored value, confirm the selected value in the display by briefly pressing the
rotary knob. The stored values are now displayed, is deactivated and no longer
flashes.
To save the current values (to blank or currently used memory slots), first push and hold
the rotary knob ( flashes), then select the desired memory slot, then hold the knob
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany mail@secabo.com www.secabo.com