Mechanical Calibration Of The Shutters - Sulky Burel X40+ ISOBUS Technician's Operating Manual

5
+ +
-
B2
3
With the spreader empty and the Stop & Go shutters open.
Remove the shaft of the application rate electric actuators.
Place a Ø 35 mm round bar
The Ø 35 mm round bar must be in contact with the bottom and the front of the opening and touch the plastic shutter.
Under these conditions the index of the application rate lever must be at mark 49
If this is not the case, the index is mounted on slot
Perform this adjustment identically on both sides
N : T D
AME RAINING EPARTMENT
R : T '
EFERENCE ECHNICIAN S
M
ECHANICAL CALIBRATION
OF THE SHUTTERS
2
1 in the shutter opening (towards the front). Then lower the shutter using the lever.
O M X40+-X50+ ISOBUS
PERATING ANUAL
3 , and therefore it must be moved in front of mark 49.
D : 2017
ATE
2
1
P :
9 / 59
AGE
I 03
ND