Set Up The Isolink - Sulky Burel X40+ ISOBUS Technician's Operating Manual

5
+ +
-
F3.1
a) Machine type:
Access the ADVANCED SETTINGS
Select "Usine" (Factory Setup)
Enter the PIN code 0035 and confi rm
Press "Option Machine" (Machine Options)
1
Press marker to select the machine type:
WPB-X ECONOV/WPB-X Stop & Go/WPB-DX Stop & go
Press to exit
b) Left Tribord Option
From the page ADVANCED
"Capteurs et actionneurs" (Actuators and sensors)
Enter the PIN code 1936 and confi rm.
Using the key display the
Tick "Tribord gauche" (Tribord left)
c) Angle sensor + weighing coeffi cients
i. Angle sensor
With the spreader connected, position the spreader level before calibrating
the angle sensor.
Scroll through the CAPTEURS ACTIONNEURS
menu with to display the page
Once the spreader is level press the key
ii. Weighing coeffi cient
Scroll through the CAPTEURS ACTIONNEURS
menu with to display the page
Enter the values: Tare point
Press to exit
N : T D
AME RAINING EPARTMENT
R : T '
EFERENCE ECHNICIAN S
S
ET UP THE
page
SETTINGS, select
Tribord page
if the spreader is fi tted with this option.
(ACTUATOR and SENSORS)
"Capteur d'angle" (Angle sensor)
(ACTUATOR and SENSORS)
"Capteur Pesage" (Weighing Cell)
and High point
O M X40+-X50+ ISOBUS
PERATING ANUAL
ISOLINK
D : 2017
ATE
1
P :
42 / 59
AGE
I 03
ND