Pre-Tensioning Spring Dimension Inspection - Sulky Burel X40+ ISOBUS Technician's Operating Manual

5
+ +
-
C5
An incorrect adjustment of the pre-tensioning spring may cause poor stability of the weight displayed.
(Inspection and adjustment to be performed when the spreader is unhitched)
A- Checking the dimension of the spring
Check that screw (A) is resting on the weight indicator with the machine unhitched.
B- Adjusting the pre-tensioning of the spring
If the dimension of the spring is not correct, you must adjust the clamping
screw at the weight indicator to compress or release the spring
1- Place a nut 1 on the pressure screw to compress the spring to height
67 < 71 mm.
2- Unscrew the cone-point set screw
3- Adjust the H20 clamping screw
weight indicator, and the pressure screw in contact with its support.
4- Tighten the cone-point set screw
5- Remove the nut on the pressure screw.
6- The calibration of the weight indicator is compulsory after this
operation. (See sheet C1 )
N : T D
AME RAINING EPARTMENT
R : T '
EFERENCE ECHNICIAN S
P -
RE TENSIONING SPRING
DIMENSION INSPECTION
2
3
until it comes into contact with the
2
O M X40+-X50+ ISOBUS
PERATING ANUAL
D : 2017
ATE
A
1
2
3
P
AGE
:
18 / 59
I 03
ND