Shutter Guides Settings - Sulky Burel X40+ ISOBUS Technician's Operating Manual

5
+ +
-
B5
5
When a shutter guide 1 is too tight, it can cause jamming at a shutter opening, before it comes
to a stop with its application rate lever
Check there is a 1 mm clearance between the bowl and the shutter with the spreader loaded.
To adjust:
1. Remove the H6 nut of the anti-bounce device
2. The shutter guide is mounted on a slot. Using screws
the metering mechanism. It is preferable to make a slightly bigger adjustment for the upper section
3. Put back the anti-bounce device and its nut
N : T D
AME RAINING EPARTMENT
R : T '
EFERENCE ECHNICIAN S
S
HUTTER GUIDE SETTINGS
4
2 .
3
O M X40+-X50+ ISOBUS
PERATING ANUAL
3
4 and 5 set a 1 mm clearance between the shutter and the bottom of
.
D : 2017
ATE
1
2
3
5 .
P :
12 / 59
AGE
I 03
ND