Bahco BBT80 Original Instructions Manual page 9

Battery tester with printer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
CHARGE)}.
13. One of the six test results will be displayed:
GOOD & PASS
*The battery is good and capable of holding a charge.
GOOD & RECHARGE
*The battery is good but needs to be recharged.
CAUTION
*The battery may be serviced but decrease the capability
of starting the engine gradually. The battery may fail under
extreme climate conditions. There may be a poor
connection between the vehicle and the battery affect the
charging function. Please pay attention to the battery for
replacement consideration and charging system checking.
RECHARGE & RETEST
*Battery is discharged, the battery condition cannot be
determined until it is fully charged. Recharge & retest the
battery.
BAD & REPLACE
*The battery will not hold a charge. It should be replaced
immediately.
BAD CELL & REPLACE
*The battery has at least one cell short circuit. It should
be replaced immediately.
LOAD ERROR
*The tested battery is bigger than 2000CCA/SAE or
200AH. Or the clamps are not connected properly.
Please fully charge the battery and retest after excluding
both previous reasons. If reading is the same, the battery
should be replaced immediately.
GOOD & PASS
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
GOOD & RECHARGE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
CAUTION
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
RECHARGE & RETEST
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
BAD & REPLACE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
BAD CELL & REPLACE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
LOAD ERROR
9

Advertisement

Table of Contents
loading

Table of Contents