Bahco BBT80 Original Instructions Manual page 10

14. SOC & SOH Display: Press directional keys to see SOC & SOH:
GOOD & PASS
SOC: xx.xx V
■■■■■■■■■□ 90%
15. Test Code:
Press <Enter> to get Test Code.
16. Press the ◄ ► key to select result printing: YES or NO.
Press «ENTER» to confirm your choice.
*24V System Test Printing: The printer will not
function for 24 Volt batteries system test printing.
The 24V system test result will be recorded till you
hook up to a 12V battery and the right screen
shows up. Please select "YES" and press enter
key to print the result and then disconnect the clamps. The screen will appear again after
you reconnect the clamps. Please select "NO" and press the enter key to go back to the
main menu.
17. Press «ENTER» return to MAIN MENU or remove the test clamps from the battery posts after
completion of testing batteries to end test.
SYSTEM TEST:
1. Select "SYSTEM TEST" from the main menu.
2. Turn off all vehicle accessory loads such as light, air
conditioning, radio, etc. Before starting the engine.
3. When the engine is started, one of the three results will be displayed along with the actual
reading measured.
CRANKING VOLTS NORMAL
The system is showing normal draw. Press «ENTER» to
perform the charging system test.
GOOD & PASS
SOH: xxxx
CCA/SAE
■■■■■■■■■□ 90%
CODE
xxxxxxxxxxxx
PRINT RESULT?
YES/NO
PRINT 24V SYSTEM
RESULT? YES
SYSTEM TEST
xx.xx V
TURN OFF LOADS
START ENGINE
CRANKING VOLTS
xx.xx V NORMAL
10