Bahco BBT80 Original Instructions Manual page 8

6. Press «ENTER» to confirm choice.
7. Press the ◄ ► key to input the battery capacity.
CCA/SAE: 40~2000
EN: 40~1885
DIN: 25~1120
IEC: 30~1320
JIS: By Battery Type No.
CA/MCA: 50~2400
8. Press the ◄ ► key to confirm temperature.
9. Press <<Enter>> to begin the test.
*Return Feature: Before the test is started, the user can always return to the previous
setting page by pressing <<ENTER>> for 2 seconds.
SURFACE CHARGE NOTICE:
The battery will hold a surface charge if the engine has been running or after the battery has
been charged. The tester may prompt you to remove the surface charge.
A. Follow the instructions indicating when to turn the headlights on and off or apply a load into
the battery.
IN VEHICLE:
SURFACE CHARGE IN
VEHICLE? YES
OUT OF VEHICLE:
SURFACE CHARGE IN
VEHICLE? NO
B. The tester will resume testing after it detects that the
surface charge is removed.
10. Test the battery for few seconds.
11. Press the ◄ ► key to select battery fully charged or not if
tester asks. Press «ENTER» to confirm choice.
12. When the test is completed, the display shows the actual volts and the actual CCA and internal
resistance. {Press the ◄ ► key to read: SOH (STATE OF HEALTH) and SOC (STATE OF
SELECT CAPACITY:
560CCA/SAE
ABOVE 32°F/0°C?
YES/NO
TURN HEADLIGHTS ON FOR
15 SECS
TESTING
TESTING
IS BATTERY CHARGED?
YES/NO
8