Furuno FMD-3100 Instruction Manual page 70

1. INITIAL SETTINGS AND ADJUSTMENTS
• Drift And Radius
[Title]: Enter the title of the component.
• Dual Azimuth Promotion
[Title]: Enter the title of the component.
[Location]: Select the position of thruster ([FORE] or [AFT]).
[Title]: Enter the title to show at the top of the indicator.
[Degree]
[Actual]: Set the source of the angle which the needle of the outer periphery points
to (feedback angle of the thruster).
[Order]: Set the source of the angle which the needle of the inner periphery points
to (actual azimuth of the thruster).
[Unit]: Enter the unit of measurement for the azimuth of the thruster.
[RPM]/[MW]/[Lever]
A maximum of three data can be displayed under the indicator.
[Label]: Enter the name of the data shown beneath the analog indicator,
[Source]: Set the source of the data that appears beneath the analog indicator.
[Unit]: Enter the unit for the data that appears beneath the analog indicator.
• Dual Dial Meter
[Title]: Enter the title of the component.
1-64