Furuno FMD-3100 Instruction Manual page 22

1. INITIAL SETTINGS AND ADJUSTMENTS
Item
[VNC Connection
Enable]
[Sub Display
Mode]
[Server IP
Address]
[Server Port
Number]
[Server Login
Password]
[Additional
Parameters]
4. Click [Serial Input/Output] of [No.1 ECDIS] on the menu bar.
The PCU-3010 has four serial interface ports ([Serial 01] to [Serial 04]).
[Serial 01] and [Serial 02] can input/output at 38,400 bps. For high-speed signal
input (such as AIS and Gyro), click [Details] to set the baud rate as 38,400 bps.
The connector no. on the I/O board of the panel computer unit PCU-3010 and the
corresponding serial port no. are shown in following tale.
Connector No. Serial Port No.
5. Check the applicable checkboxes of [Serial No.] according to sensor connection.
6. Set the items referring to the table shown below.
1-16
Not used.
COM1 (C1) Serial 01
COM2 (C2) Serial 02
Remarks
Connector No. Serial Port No.
COM3 (C3) Serial 03
COM4 (C4) Serial 04