Connecting The Snom D7C To A Snom Phone - Snom D7C User Manual

Snom D7C User Manual
C
onnecting the Snom D7C to a Snom phone
The connectors are marked A, B, and C. Connectors A and B are used to attach the footstands of D7C
and the phone, connector C is used to connect the footstands of two D7Cs:
◦
A: connecting to D717, D735, and D765.
◦
B: connecting to D785. There is also a smaller plate marked B to connect the D7C and the
D785 more securely.
◦
C: connecting a D7C to another D7C.
You can connect up to three Snom D7Cs to one of the supported Snom phones. The first expansion
module is supplied with power by the phone via the module's USB cable. The second module is
supplied with power by one of the separately available power adapters. The third expansion module
is supplied with power by the second module via the third module's USB cable.
Note: In some cases, e.g. if you connect a device requiring a lot of power to the USB
port of the D7C, you may also need to attach a power adapter to the third and the first
module in the daily-chain.
1. Place a soft cloth on the desktop so that the display does not get scratched or otherwise damaged
if you lay the device down.
2. Attach the respective footstand to the D7C expansion module and to the phone.
3. Place the USB cable of the D7C into the cable guide (Fig. 1).
Fig. 1
4. Connect the expansion module to the phone, as shown in Fig. 2. If the phone has two USB ports
(Fig. 3), either one can be used.
Fig. 2
Cable guide
Fig. 3
7
Setting up the expansion module