Snom D7 Series Quick Start Manual

Hide thumbs Also See for D7 Series:

Get the snom phone ready for operation

First of all, unpack your Snom Phone and put it on the table.

To connect it use the enclosed network cable and connect the "

the center of the 7 series devices. On devices of the 3 series, it is usually on the left.

To get power for your Snom Phone either a network switch with "

(usually 5V - No guarantee for damage when using an external power supply).

At the "

" socket you can connect your computer to the workstation.

These ports support

When connecting the handset to the phone, please note that the short end is connected to the handset and the long end is plugged into the

"handset" jack of the phone.You need the longer part for strain relief.

802.1X

authentication.

Net

" socket of your telephone to your network switch. The Net port is usually in

POE

" (Power over Ethernet) or a suitable Snom power supply (A6) unit

Table of Contents

Do you have a question about the D7 Series and is the answer not in the manual?

Page 1 Get the snom phone ready for operation Connect First of all, unpack your Snom Phone and put it on the table. To connect it use the enclosed network cable and connect the " " socket of your telephone to your network switch. The Net port is usually in the center of the 7 series devices.
Page 2 Mount the Footstand - D7xx Series The base of the 7 series can be mounted for the usual standing position and for a lying position. For the classic standing position, you have to slide the short end of the foot down and the long one to the right from below into the rails of the phone until it locks.
Page 3 Please note the following instructions for securing your Snom phone after you have put it into operation: How do I secure my Snom phone Further Information VoIP Essentials Visit the Snom Forum Open a support ticket Find a local partner Related articles Hallo.

D3 series