Snom D7C User Manual page 24

Snom D7C User Manual
◦
Before the update, disconnect other modules from the phone.
Note: After an update via provisioning, the
phone's URL to keep the phone from repeatedly downloading the update file and
updating the expansion module. If you are provisioning updates for more than one
D7C from the same phone, you must replace the phone's URL in the
parameter with the update file's URL before updating the next module.
1. Connect the expansion module you want to update to your phone. Wait until its LEDs have lit up
and gone out and the labels are shown on the display.
2. Set the
firmware_status
is shown on the phone's display. When the update has been completed, phone and expansion
module will reboot.
3. Repeat for each module to be updated.
firmware_uxm
setting to the update file's HTTP URL. The progress of the update
24
Firmware update
parameter is set to the
firmware_uxm