Restoring Factory Settings - Zoom ADSL X2 Quick Start Manual

•
Monitor how fast the modem is transferring data (Downstream Speed and
Upstream Speed).
To view the ADSL Status page, log into the Zoom Configuration Manager
(please see step 1 on page 2). Then click the ADSL Status icon at the top of the
page.
Checking the System Status Page
You can use the System Status page when you want to:
•
Check how long it has been since you last rebooted the modem (Up time
setting)
•
View your WAN and LAN settings
To view the System Status page, log into the Zoom Configuration Manager
(please see step 1 on page 2). Then click the System Status icon at the top of the
page.
Changing the Password of the Zoom Configuration
Manager
1 1 1 1
To change the password, log into the Zoom Configuration Manager
(please see step 1 on page 2). Then click the Advanced Setup icon at the top
of the page.
2 2 2 2
Click the User Configuration button located in the Administration group
on the Advanced Setup page.
3 3 3 3
On the User Configuration page, locate the row that contains the admin
username.
4 4 4 4
Click the pencil icon at the right end of the row to open the User Config –
Modify screen.
5 5 5 5
In the Old Password box, enter zoomadsl in lowercase letters.
6 6 6 6
In the New Password box, enter the new password you would like to use.
The password is case sensitive and cannot exceed 128 characters.
7 7 7 7
In the Confirm Password box, enter the new password again to confirm it.
8 8 8 8
Click Save Changes. A message appears to let you know that the password
has been changed. Click Close to return to the User Configuration page.
9 9 9 9
Click Write Settings to Flash.

Restoring Factory Settings

If you have changed the system settings on your modem and want to restore them
to the factory settings, you can do so in one of two ways: You can perform a
software reset or a hard reset.
Doing a Software Reset
1 1 1 1
Log into the Zoom Configuration Manager (please see step 1 on page 2).
Then click the Advanced Setup icon at the top of the page.
2 2 2 2
In the Administration section, click the Reboot button.
3 3 3 3
From the Reboot Mode drop-down list, select Reboot From Default
Configuration.
4 4 4 4
Click the Reboot button. When this process completes, your unit will be
restored to its factory settings.
3