Advertisement
H•KING
6. Insert the wing joining spar into one of the wing panels then slide that wing panel into the
followed by the remaining wing panel (A). Use a pair of small pliers
in the bottom of the fuselage to help you pull all wires through into the
as shown (B).
pulled through, secure the wing In
SET-UP
1. With the recommended 2200mah 3S lipo installed as shown here your Night Walrus
should balance at the CG point of 71 mm from the leading edge. However this depends on
the weight of battery used so adjust battery position accordingly to achieve the correct
CG.
Use the supplied Velcro to secure the lipo in place.
5
ploco
using the supplied bolts
:
1
·
•
·Approximate battery location for
2. With your receiver installed directly under the wing in th
into their corresponding channels, connect the lipo to th
electronics.With the model now armed, ensure servo's ar
level. If not, adjust either via your radio or by hand Li n tll i.lll
NOTE: For safety reasons, it is advised that this is done with the prop removed from the
model.
Check all control surfaces move in the correct direction with the applicable stick input
(see below)
Roll left
Roll right
'
'I
Pitch up
Pitch down
I
\
fuselage and all servo's plugged
to power up the
ntered and all control surfa
1J
li
1J
li
1J
li
Aileron
(Roll)
Elevator
(Pitch)
Advertisement
