Table of Contents
Advertisement
2-12. Taking Out the Cassette in Tape Slacking
2-12. Taking Out the Cassette in Tape
Slacking
When the tape is slacked in this unit, follow the steps
below to take out the cassette tape.
n
Being careful not to damage the tape, take out the cassette
tape with care.
1. Turn off the power.
2. Remove the upper lid. (Refer to Section 2-3-1.)
3. Remove the plate MD assembly.
(Refer to Section 2-4.)
4. Rotate the M gear of the threading motor block in the
direction of the arrow with the fingers by about a half
turn to slack off the tape.
5. Pull the ME lever toward the front panel side to take
up the tape inside the cassette.
6. To wind up the tape, repeat steps 4 and 5.
2-20
M gear
Threading motor
ME lever
7. Turn the lower control panel upward.
(Operation side up).
8. Turn the wheel of the cassette compartment motor
clockwise as shown in the figure until the cassette is
completely ejected.
Wheel
Up
Cassette compartment
Cassette
compartment
Down
motor
DNW-A22/A22P
Advertisement
Table of Contents
