Table of Contents
Advertisement
2-16-2. F-Series Items
No.
ITEM
F01
AUDIO NR IN SP
MODE
F02
EMERGENCY TAPE
PROTECTION
F13
TRACKING CONTROL
VIA SEARCH DIAL
F16
DEVICE TYPE
MODIFY:0H
F34
STOP PINCH OFF TIME
DNW-A22/A22P
Settings
Description
[ON]
n
SW
This item is used exclusively for analog Betacam longitudinal audio playback
adjustment for 625/50 system.
After adjustment is completed, return to the factory setting "ON".
Turns on and off the Dolby NR when using a metal tape.
ON: Dolby NR is turned on usually
SW: Dolby NR switch is turned on and off depending on the setting of the sub
control panel
n
When using an oxide tape, follows the sub control panel switch setting regardless
of the above setting.
[ENA]
n
DIS
This item is used exclusively for servo and mechanical adjustment.
After adjustment is completed, return to the factory setting "ENA".
Selects whether emergency tape protection operation is enabled or not when VTR
detects error in tape transport mechanism.
ENA: Tape protection operation is enabled
DIS: Tape protection operation is disabled
[OFF]
n
ON
This item is used exclusively for video tracking adjustment.
After adjustment is completed, return to the factory setting "OFF".
Turns on and off the tracking control operation with search dial.
OFF: Tracking control with SHUTTLE dial is not activated
ON: Tracking control becomes active when turning SHUTTLE dial in PLAY mode
[0]
Determines response data to 9-pin remote command DEVICE TYPE REQUEST
1
(00h, 11h).
|
0:
Returns the original device type data of the unit
FFFF
Except 0:
Returns the set values as they are:
The higher-order two digits are for DATA-1
The lower-order two digits are for DATA-2
n
Any selection of the above does not influence the whole VTR operation including TTP.
If this item is set to values other than the factory setting "0", the operation
of the unit is not ensured under the 9-pin remote command control.
0 M
Specifies the time at which the pinch ON condition is kept even if the PB operation
[5|M]
is completed in the SX tape PB mode. The time is usually set to "5 M". When
10 M
"0 M" is set, the pinch is turned off as soon as the PB operation is completed.
15 M
20 M
n
When the pinch is turned off, it takes a few seconds to output image and sound
signals during PB operation of the next time.
2-16. Setup Menu (F-series)
2-29
Advertisement
Table of Contents
