Table of Contents
Advertisement
2-5. Removing/Reattaching Cassette Compartment
2-5. Removing/Reattaching Cassette
Compartment
m
. Turn off the power and unplug the power cord before
starting the removal/installation.
. The cassette compartment cannot be removed with the
cassette tape inserted. Press the EJECT button with the
power turned on to eject the cassette tape.
If the cassette compartment does not move due to an
electric trouble, take out the cassette tape manually.
(Refer to "2-12. Taking Out the Cassette in Tape Slack-
ing".)
Removal
1. Remove the upper lid. (Refer to Section 2-3-1.)
2. Remove the plate MD assembly.
(Refer to Section 2-4.)
3. Loosen the two screws, then remove the cassette
compartment bracket assembly.
4. Disconnect the harness from the connector (CN930)
on the CL-29 board. Keep the harness out of the way
of the removal.
B3 x 6
(with stopper)
2-6
Cassette compartment
bracket assembly
B3 x 6
(with stopper)
Harness
CN930
5. Hold the cassette compartment at the portions A and
lift up the cassette compartment slightly (by 1 cm).
When the four cassette compartment positioning legs
come off from the four positioning holes on a mechan-
ical deck, shift the cassette compartment backward (by
1 cm) to the position where the cassette lid can be
completely seen when viewed from just above.
6. Hold the cassette compartment at the portions B, then
slowly raise the cassette compartment upward to
remove it.
m
. Being careful not to contact the gear on the right of
the cassette compartment with the chassis, slowly
raise the cassette compartment while slightly sliding
it back-and-forth.
. Never move the cassette compartment to the right
and left. If unnecessary force is applied to right and
left, the gear or part may come off.
. Place the cassette compartment with the cassette lid
up or with cassette compartment positioning legs
down.
(If it is put with the cassette lid down, the flexible
card wire/board might be damaged.)
Cassette compartment
A
B
A
DNW-A22/A22P
Advertisement
Table of Contents
