Rear Panel Assembly; Replacement Of Main Parts - Olympus OEP-3 Service Manual

2-2-3. Rear Panel Assembly

1. Remove the top cover. (Refer to Section 2-2-1.)
2. Remove the VPR-63 board. (Refer to Section 2-3-1.)
3. Disconnect one flexible flat cable from the connector
(CN207) on the SY-282 board.
4. Remove the five screws, then remove the rear panel
assembly.
Flexible flat cable (25-pin)
SY-282 board
Connector
(CN207)
5. Install the rear panel assembly in the reverse order of
steps 1 to 4.
OEP-3 V1 (UC)
Rear panel
assembly
BVTT 3x6
BVTT 3x6
BVTT 3x6

2-3. Replacement of Main Parts

2-3-1. Replacement of VPR-63 Board
1. Remove the top cover. (Refer to Section 2-2-1.)
2. Disconnect the four flexible flat cables from the
connectors (CN101, CN102, CN103, and CN105) on
the VPR-63 board and one harness from the connector
(CN104).
3. Remove the four screws, then remove the VPR-63
board.
4. Remove the four screws, then remove the VPR frame
from the VPR-63 board.
Harness
Flexible flat cable (24-pin)
Flexible flat cable (30-pin)
BVTT
3x6
Connector
VPR-63
(CN102)
board
BVTT
Connector
3x6
(CN101)
VPR
frame
5. Install a new VPR-63 board in the reverse order of
steps 1 to 4.
Flexible flat cable (18-pin)
BVTT
3x6
CN105
BVTT
3x6
Connector
(CN104)
Connector
(CN103)
2-3