Front Panel Assembly - Olympus OEP-3 Service Manual

2-2. Removal and Installation of Cabinet
2-2-1. Top Cover
1. Remove the M3 case screws, then remove the top
cover.
Top cover
M3 case screw

2-2-2. Front Panel Assembly

1. Remove the top cover. (Refer to Section 2-2-1.)
2. Open the front door in the direction indicated by arrow
1.
3. Press the EJECT button and take out the cartridge in
the direction indicated by arrow 2.
4. Press the PUSH portion of the paper feed tray and take
out the tray in the direction indicated by arrow 3.
5. Take out the delivery tray in the direction indicated by
arrow 4.
EJECT button
Cartridge
2
Delivery tray
P U
S H
3
PUSH portion
2-2
M3 case screw
M3 case screw
1
4
1
Front door
Paper feed tray
6. Remove the two screws (PSW 3 x 6) and one screw
(BVTT 3 x 6).
7. Disconnect the flexible printed wiring board from the
connector (CN502) on the PRT-13 board.
8. Remove the four hooks, then remove the front panel
assembly.
9. Remove the VPR-63 board. (Refer to Section 2-3-1.)
10. Disconnect the two flexible flat cables from the
connectors (CN204 and CN205) on the SY-282 board.
11. Remove the power switch rod.
Flexible flat cable (14-pin)
Power switch rod
Connector
(CN502)
PSW
3x6
Hooks
12. Install the front panel assembly in the reverse order of
steps 1 to 11.
Flexible flat cable (12-pin)
SY-282 board
Connector
(CN204)
Connector
(CN205)
PRT-13 board
Flexible printed
Hook
wiring board (16-pin)
BVTT 3x6
Front panel assembly
OEP-3 V1 (UC)