Olympus OEP-3 Service Manual page 92

14. Remove one pawl and two hooks, then remove the
paper feed tray guide.
15. Remove the four screws (BVTT 3 x 6) and the three
harness of the paper feed assembly.
16. Shift the paper feed assembly in the direction indicated
by arrow 1 and remove the three hooks.
n
Be sure not to deform or damage the sensor, gear, or
lever.
17. Remove the paper feed assembly while inclining it in
the direction indicated by arrow 2.
Paper feed assembly
Lever
BVTT
Hooks
3x6
Mechanical
block 2
1
BVTT
3x6
Hook
18. Install a new paper feed assembly in the reverse order
of steps 1 to 17.
2-12
Harness
BVTT 3x6
Harnesses
BVTT 3x6
Sensor
Sensor
Mechanical
chassis B
Paper feed
tray guide
Hooks
2-3-16. Replacement of Paper Feed Motor
1. Remove the top cover. (Refer to Section 2-2-1.)
2. Remove the front panel assembly.
(Refer to Section 2-2-2.)
3. Remove the mechanical block.
(Refer to Section 2-3-8.)
4. Remove the PRT-13 board. (Refer to Section 2-3-6.)
5. Remove the cartridge guide. (Refer to Section 2-3-7.)
6. Remove the paper feed assembly.
(Refer to Section 2-3-16.)
7. Remove the two screws, then remove the paper feed
motor.
8. Remove the two solders on the SU-54 board.
Paper feed assembly
Two solders
SU-54 board
9. Install a new paper feed motor in the reverse order of
steps 1 to 8.
Belt 50TN
PS2.6x4
Harness
Paper feed motor
OEP-3 V1 (UC)