Sony MCC-3000MT Service Manual page 42

11. Disconnect the harness from the connector (CN600) on the AVP-18 board.
AVP-18 board
CN803
Flexible flat cable
Harness CN900
Note
When installing, arrange the harness as shown in the figure.
12. Remove the four screws to detach the main board assembly (for CAMERA A).
Main board assembly
(for CAMERA A)
Note
When installing the main board assembly (for CAMERA A), fit the two bosses with the two holes.
13. Install the removed parts by reversing the steps of removal.
MCC-3000MT
Harness CN1400
CN1700
DPR-340 board
Coaxial cable
Hole
B3 x 6
Hole
Bosses
Coaxial cable
CN1301
B3 x 6
CN600
Harness
Clamps
2-10