Canon EOS-1V Service Manual page 71

ADJUSTMENT PROCEDURE
1) On the AE Adjustment Menu, select
[F1] SPC positioning. The approximate
EV of the SPC's metering sensors will
be displayed.
2) As shown in the figure below, block
the light at the four holes at the bot-
tom and take EV readings of the S0
sensor.
3) As shown in the figure below, block
the light at the left, top, and bottom
individually and take EV readings
from the S0 sensor each time.
4) Move the SPC to position it so that the readings displayed for the top, bottom,
left, and right are within 2 stops.
5) After the adjustment, use instant glue to set the SPC holder in place. After
attaching the cover, do steps 2) and 3) again to check it.
AESPC
SPD Position Adjustment
S20
00.0
S18
00.0
When adjustment is finished, press RETUEN
Fig. 4-8 SPC positioning.
4-17
Part 4: Electrical Adjustments
Unit : EV
S14 S12 S13
00.0 00.0 00.0
S16 S15
00.0 00.0
S8 S7
00.0 00.0
S4 S2 S0 S1 S3
00.0 00.0 00.0 00.0 00.0
S6 S5
00.0 00.0
S11 S9 S10
00.0 00.0 00.0
to return to AE Menu screen.
S19
00.0
S17
00.0