Canon EOS-1V Service Manual page 24

Part 1: General Information
7-3 Flash exposure
compensation:
7-4 FE lock:
7-5 Wireless flash:
8. Film ID Imprinting
(Built-in with EOS-1V's camera back.)
8-1 Imprinted infor-
mation:
8-2 User-selectable No.: With no film loaded, press the Multi Function button
8-3 Imprinting posi-
tion/size:
8-4 Imprinting method: After the film loads, a minilamp imprints transparent
8-5 Imprint confirma-
tion:
8-6 Imprinting time:
8-7 Power source:
(1) Manual setting
1) Increments: →3 stops in 1/3-stop increments
2) Procedure: Metering mode button + Quick
Control Dial or Metering mode button + Focusing
point selector + Main Dial
(2) FEB (Flash Exposure Bracketing)
Enabled and set with the 550EX, MR-14EX.
When the flash is unable to fire anymore during
FEB continuous shooting, the shutter release locks.
The shutter release unlocks when the SW-2 is
released. If the flash is not ready, the AE mode
takes effect.
* If flash exposure compensation has been set with
both the EOS-1V and external Speedlite, the
Speedlite's setting will take effect.
With E-TTL autoflash Speedlites, FE lock is set with
the FE lock button.
* FE lock is effective for 6 sec. Pressing the button
again renews FE lock.
* FE lock is canceled if any of the following occurs: 6
sec. elapse, the main switch is set to L, one of the
mode buttons (BC, CLEAR, REW, CF) is pressed.
Enabled.
* With the 550EX, MR-14EX, or ST-E2, those
Speedlites set as slave units will fire a preflash and
meter the light reflected off the subject with the AE
metering sensor. The flash output is then set and
stored in memory and wireless flash is fired.
* Wireless high-speed sync (FP flash), FE lock, and
automatic fill-in flash are also possible.
User-selectable two-digit number (00 - 99) and 3-digit
film ID No. (001 - 999).
to set the film ID setting mode, then turn the Main
Dial to set the desired two-digit No. (00 - 99).
Imprinted on frame 0 on the film leader. Text height is
about 1 mm.
LCD digits through the film base (imprinting cannot be
disabled).
During imprinting, the ID symbol is displayed on the
LCD panel.
* If the shutter is released during imprinting, the shut-
ter release will override the imprinting.
ISO
64 or lower 80 ~ 125
[ms] 180 120
Same as used by the camera.
1-22
160 ~ 250 320 ~ 500 640 or higher
80 40
NON DX
25 88