Canon EOS-1V Service Manual page 217

<D P
ISASSEMBLY ROCEDURE
(1) Remove the top and bottom covers.
• The covers are held together by hook lugs. Insert a blade screwdriver into the
gap between the covers and pry them apart. Note that one of the covers will
have to be replaced as a result.
(2) Remove the top and bottom shield cases.
• Remove the soldered parts at the four corners.
(3) Remove the two cables at the soldered ends.
• On the USB side of the cable, remove the connector at the four soldered points.
• On the three-pin connector side of the cable, unsolder the three lead wires.
<R C >
EASSEMBLY AUTIONS
1. Check for any problems with the soldered places.
2. Make sure the stickers are affixed in the proper direction on the top and bottom
covers with regard to the three-pin connector. (When you look at the sticker right
side up, the three-pin connector must be on the right side of the sticker.)
Three-pin connector on the
Fig. 3-3 Canon logo sticker.
Red
>
right→
Black
White
Fig. 3-5 Main board and lead wires.
3-3
Part 3: Repair Information
Three-pin connector on the right→
Fig. 3-4 Notice label.
USB Connector
Black