DENTSPLY DeguDent Degutron eco Instructions For Use Manual page 20

1 Introduction
Use as determined/liability
This casting machine is designed and manufactured to
comply with the latest technical knowledge and according
to approved safety regulations. When not putting into
operation correctly or not using the machine as determined,
however, danger and damages may occur. Therefore we
suggest reading carefully and completely this manual
before putting the machine into operation and to follow the
instructions given therein:
• T his machine is only to be used for melting, and casting
of common dental alloys. Melting unknown alloys can be
hazardous by toxic substances. Its released exhaust air
shall not be set free. The risk analysis shall be evaluated
in advance.
• D o not melt substances which are inflammable or can
form an explosive gas during melting.
• F or melting already inserted alloys appropriate safety
cloths are required such as rubber gloves, masks, etc.
• T his machine may only be connected as mentioned in
this manual. The mains supply as well as in- and
outgoing pressures are to be provided as stated on
the machine label.
• T his machine was designed for use in closed spaces
(indoors) and may only be used for the above-mentioned
purpose.
• T his unit is designed for a maximum of six castings
per hour.
• D eguDent does not take over responsibilty for any
damage, caused by non original DeguDent consumables
and spare parts, unless the damage occurred indepen-
dently.
20
eco
Degutron
®
• T he machine may not be changed or modified. Technical
changes may be accomplished only with the written per-
mission of DeguDent GmbH.
• D isregarding or wrong interpretation the data in this
operating instructions DeguDent is not responsible for
damage, unless the damage occurred independently.
• T his instruction manual is conform to the latest technical
condition of the machine when printed. Technical chan-
ges and fittings are subject to change.