Mounting Instructions - Mark Bric ISOframe Wave IS-9402-1 Mounting Instructions

Wave Comapct
modules
Straight modules
Midi 229 cm / 90.2"
Starter kit IS-9402-1
Extension kit IS-9404-1
Maxi 249 cm / 98.0"
Starter kit IS-9402-2
Extension kit IS-9404-2
22,5° iside curved modules
Midi 229 cm / 90.2"
Starter kit IS-9403-1
Extension kit IS-9405-1
Maxi 249 cm / 98.0"
Starter kit IS-9403-2
Extension kit IS-9405-2
1
Begin by attaching the foot on
the base post. Mount the stem
on the foot into the front slot and
lock the FASTclamp.
5
Complete the post with a top
posts section with the plastic
top hub.
Mark Bric Display Corp.
North America Tel. 800.742.6275 Fax 800.565.9506 E-mail: markbric@markbric.com
Mark Bric Display AB
Worldwide Headquarters Tel. +46 33 480 460 Fax +46 33 480 470 E-mail: display@markbric.se
Starter kit complete with:
2 post sets, 2 feet, 2 beams
2 sets corner trim, 1 set kicker and hanger
Magnetic tape for graphic panels are not included.
50 mm / 2"
2
Insert a beam 50 mm from
the floor (see marks) and lock
the FASTclamps.
6
Mount now the secend beam
at the top of the system.
The starter kit is now ready for a
graphic panel.
Extension kit complete with:
1 post set, 1 foot, 2 beams,
1 set kicker and hanger
7
Now you can add an Extension Module (Flex-
Link or Fixed beam) onto the starter section
just built. Create a foot+base post+Flexi-Link/beam
assembly as before.

Mounting instructions

Accessories
Padded case on wheels
Holds up to a 6 section Wave system.
Item IS-TC-01-MB
Small graphic tube
to be attached to frame case
Holds up to 6 panels,
Item IS-0850-RTS-S-MB
4
3
Mount the extension post on
top of the base post.
8
Follow the procedures shown above to build
the new post to the height of the starter section.
Add more modules as desired. Finish the system to
add 1 set of corner trim in each end.
Large graphic tube,
with handle and shoulder strap.
Holds up to 9 panels,
Item IS-0850-RTB-S-MB
If you want Maxi height, add
a short extension post before
you mount the top post.