Mark Bric ISOframe Wave IS-9402-1 Mounting Instructions page 25

Graphic panel production
Wall graphic
Table graphic
A template for the graphic panel
production can be downloaded at:
http://markbricdisplay.net/imagebank/PT-general.html
Graphic panel
attachments
Accessories
Kickers & Hangers
800 mm / 31 1/2" Item: IS-800-KHN
Magnetic tape (not incl.)
12 mm/0.5", Item: 82281
24 mm/1" Item: 82282
12 mm vertical
magnetic tape on
edge of the graphic
Mark Bric Display Corp.
North America Tel. 800.742.6275 Fax 800.565.9506 E-mail: markbric@markbric.com
Mark Bric Display AB
Worldwide Headquarters Tel. +46 33 480 460 Fax +46 33 480 470 E-mail: display@markbric.se
Midi
800 mm / 31 1/2"
1013 mm / 39.9"
Hanger strip
Horizontal magnetic tape
directly below hanger strip
Vertical magnetic tape
on edge of the graphic
Horizontal magnetic tape
directly over the edge
Kicker strip not needed in this setup!
12 mm horizontal magnetic tape directly below the edge
24 mm
313 mm / 12.3"
313 mm / 12.3"
vertical
magnetic
tape
12 mm horizontal magnetic tape directly over the edge
Maxi
800 mm / 31 1/2"
Printer material
We recommended the following material:
Poster paper: 180 gr / 0.4 lb.
The printed graphic panels must be laminated before use.
Front side: 125 microns (0,125 mm) / 0.005"
Reverse side: 250 microns (0,250 mm) /0.010""stop light"
Polyester film: 330-370 microns (0,350 mm) / 0.013-0.015"
Top laminate: 125 microns (0,125 mm) / 0.005"
Kicker Hanger
Mounting of Kickers and Hangers
Kickers and hangers to be fixed at the bottom and at the top of the graphic
panels (reverse side).
Mounting of Magnetic Tape
Magnetic tape to be fixed horizontally directly over/under kicker/hanger strip.
Magnetic tape to be fixed vertically along each side of the graphic panels.
IMPORTANT Carefully mount the magnetic tape slightly inset from the edge of
the graphic panel by approximately 0,25 mm / 0.010". Once mounted, a very
thin straight white line should show between the edge of the graphic and the
outside edge of the magnetic tape. Do not exceed 0,5 mm / 0.020".
Application Techniques
To obtain optimum adhesion, the bonding surfaces must be well unified, clean
and dry. Typical surface cleaning solvents are isopropyl alcohol/water mixture
(rubbing alcohol) or heptane.
Note: Be sure to follow solvent manufacturer's precautions and directions for use
when using solvents.