Mark Bric ISOframe Wave IS-9402-1 Mounting Instructions page 10

Showcase modules
– Single height
Item.no: Midi IS-9410-1
Maxi IS-9410-2
Complete with:
Midi IS-9410-1
1 Wave base post, 763 mm IS-W763-BPH
1 Extension post, 750 mm IS-0750-EP
1 Top post, 755 mm IS-0755-EP
3 Extension post, 200 mm –––––––
1 Wave foot IS-WFT-02
2 Base post IS-0750-BP
2 Extension post, 750 mm IS-0750-EP
2 Top post, 755 mm IS-0755-TP
5 Straight beam, 800 IS-800-BS
4 Straight beam, 400 IS-400-BS
1 Slatwall panel, black, 800 IS-SW-02
2 Slatwall panel, black 400 IS-SW-04
1 Base shelf, black IS-SW-08
2 Shelf bracket IS-SW-10
1 Top shelf, White IS-SW-09
2 corner trims, 763 mm IS-0763-CT
1 Kickes & Hangers IS-800-KHN
Not
included!
1
Build the bottom housing of
the showcase by connec-
ting two 800mm/31.5" and two
400mm/15.75" standard beams.
6
Slide in the two side panels
from the top.
Mark Bric Display Corp.
North America Tel. 800.742.6275 Fax 800.565.9506 E-mail: markbric@markbric.com
Mark Bric Display AB
Worldwide Headquarters Tel. +46 33 480 460 Fax +46 33 480 470 E-mail: display@markbric.se
Maxi IS-9410-2
IS-W763-BPH
IS-0750-EP
IS-0755-EP
IS-0200-EP
IS-WFT-02
IS-0750-BP
IS-0750-EP
IS-0755-TP
IS-800-BS
IS-400-BS
IS-SW-02
IS-SW-04
IS-SW-08
IS-SW-10
IS-SW-09
IS-0763-CT
IS-800-KHN
2
First determine the desired height
for the bottom shelf. Adjust the
6 stop screws so that the top edge of
the stop screw is 105mm/4.1 inches
below desired shelf height.
7
Attach the four top posts, one
800 mm beam across the back,
and two 400 mm beams on the
sides at the top of the panels.
3
Mount the extension posts and
move up the side and back
beams to the top of the stop screw,
8
Mount the final 800 mm beam
across the front, with top of
beam even with bottom edge of the
center slot in the side beams.
Mounting instructions
Accessories
Shelf bracket
320 mm / 12.6"
Item IS-SWQ-10
Shelf, grey
700x350 mm / 27.5x13.8"
Item IS-SWQ-05
Shelf, grey
700x350 mm / 27.5x13.8"
Item IS-SWQ-06
4
Slide the rear panel in place,
from the top, and attach the
shelf brackets on the bottom slot in
the slatwall.
9
Slide in the top shelf in the track
of the back side 800 beam .
5
Insert the bottom shelf. Attach a
800 mm beam until it touches
the below the shelf.
10
This completes the
Showcase.