Resetting To The Factory Default Settings - Eneo ISD-52F0023WSA Quick Installation Manual

1/2.8” network dome compact, 1920x1080, day&night, wdr, 2.3mm, h.265, poe, 12vdc
Table of Contents

Advertisement

Available languages

Available languages

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera inside the bottom cap.
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the top cap.
3. Press and hold the Reset button with a straightened paperclip while reconnecting
the power.
4. Keep the Reset button pressed about 5 or more seconds.
5. Release the Reset button.
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
7. Close the bottom cap tightly to ensure waterproofness.
CAUTION: When performing a Factory Reset, you will lose any settings that have been
saved. (Default IP 192.168.1.10)
Reset Button
microSD Card Slot
EN
11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ISD-52F0023WSA and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Isd-52f0023wfa227007227008

Table of Contents