Resetting To The Factory Default Settings - Eneo ISM-52F0023W0A Quick Installation Manual

Notice: If the password is lost, the network camera must be reset to the factory
i
default settings. Please see "Resetting to the Factory Default Setting".

Resetting to the factory default settings

To reset the network camera to the original factory settings, go to the Setup > System >
Maintenance web page (described in "System > Maintenance" of Users Manual) or use the
Reset button on the network camera, as described below.
Using the Reset button:
Follow the instructions below to reset the network camera to the factory default settings
using the Reset button.
1. Switch off the network camera by disconnecting the power adapter.
2. Open the top cap.
3. Press and hold the Reset button with a straightened paperclip while reconnecting
the power.
4. Keep the Reset button pressed about 5 or more seconds.
5. Release the Reset button.
6. The network camera resets to factory defaults and restarts after completing the
factory reset.
7. Close the bottom cap tightly to ensure waterproof.
CAUTION: When performing a Factory Reset, you will lose any settings that have
been saved. (Default IP 192.168.1.10)
EN
17