TP-Link Archer C50 User Manual page 23

Chapter 4
• ISP Specified IP Address
the router, please select
provided by your ISP in dotted-decimal notation.
• Detect Online Interval
interval. The default value is 0. You can input the value between 0 and 120. The value
0 means no detect.
• Primary DNS/Secondary DNS
addresses to the router, please select
address in dotted-decimal notation of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it as well.
L2TP
If your ISP provides L2TP connection, please select L2TP.
• Username/Password
fields are case-sensitive.
• Addressing Type - Choose the addressing type given by your ISP, either Dynamic IP
or Static IP. Click the
button to disconnect immediately.
• MTU(Bytes) - The default MTU size is "1460" bytes, which is usually fine. It is not
recommended that you change the default MTU Size unless required by your ISP.
• Enable IGMP Proxy
multicasting on TCP/IP networks. Some ISPs use IGMP to perform remote configuration
- If your ISP does not automatically assign IP addresses to
Use IP address specified by ISP
- The router will detect Access Concentrator online at every
- If your ISP does not automatically assign DNS
- Enter the user name and password provided by your ISP. These
Connect button to connect immediately. Click the
- IGMP (Internet Group Management Protocol) is used to manage
Configure the Router in Wireless Router Mode
and enter the IP address
Set DNS server manually and enter the IP
Disconnect
18