Quick Setup - TP-Link Archer C50 User Manual

Chapter 4
• Name(SSID)
• Mode - The current wireless mode which the router works on.
• Channel - The current wireless channel in use.
• Channel Width
• MAC Address
• WAN - This field displays the current settings of the WAN, and you can configure them
on the Network > WAN
• MAC Address
• IP Address
or 0.0.0.0 if the IP Address is assigned dynamically and there is no internet
connection.
• Subnet Mask
• Default Gateway
Dynamic IP as the internet connection type, click
obtain new IP parameters dynamically from the ISP or release them.
• DNS Server
• Ethernet - This field displays the current settings of the WAN and LAN ports.
• Internet - This shows whether the WAN (Internet) port of the router is connected.
• LAN1/LAN2/LAN3/LAN4
powered-on device and the negotiation speed of the LAN port.
• System Up Time - The length of the time since the router was last powered on or
reset.
Click Refresh to get the latest status and settings of the router.
4. 2.

Quick Setup

1. Visit http://tplinkwifi.net, and log in with the password you set for the router.
2. Go to Quick Setup.
3. Click Next to start. Then follow the step-by-step instructions to connect your router
to the internet.
- The SSID of the Router.
- The current wireless channel width in use.
- The physical address of the router.
page.
- The physical address of the WAN port.
- The current WAN (Internet) IP Address. This field will be blank
- The subnet mask associated with the WAN IP Address.
- The Gateway currently used is shown here. When you use
- The IP addresses of DNS (Domain Name System) server.
- This shows whether the LAN port is connected to a
Configure the Router in Wireless Router Mode
Renew or Release here to
14