Advertisement
Available languages
Available languages
- 12, 13, 14 -
- Drill a 3 mm diameter guide hole in the marked spot.
- Using a pin, check the drilled hole for correct position.
- Re-drill the hole to 25 mm diameter (use a power drill).
Advice. Drill into the C-pillar panel only.
EN
- 15 -
- Rivet the riveting nut in the hole of the C-pillar shet (under the C-pillar pnanel) using the
riveting tool MTX 9-193/A.
- Proceed as follows:
- fit the riveting nut (B) on the riveting preparation,
- insert the tool with the fitted riveting nut into the opening in the C-pillar sheet,
- by gradual tightening of the nut on the screw rivet the riveting nut,
- keep tightening the nut on the screw until it stops, otherwise the riveting nut will be lose,
- release the nut and uncsrew the preparation.
- 16, 17 -
- Screw the spacers (D) on using the tool (screw M8 x 50 and nut M8 with a washer).
- Proceed as follows:
- screw the spacer (D) on the tool screw,
- tigthen the nut to the spacer (D),
- insert the tool with the spacer (D) into the hole in the riveted nut and screw the spacer (D)
in.
- release the nut (of the preparation) and uncsrew the screw (of the preparation).
- Put the cap (E) on the outstanding spacer.
In the same way then create mounting points of the trunk grille on the other
side of the vehicle trunk.
- 18, 19 -
- Insert he trunk grille (A)into the trunk of the vehicle and adjust it to the prepared mounting
points.
Caution Make sure not to damage the ceiling panel, lining of the trunk
or the C-pillar panel.
- Fasten the grille using the plastic-head screws (G). Tighten the bolts with hand until they
stop.
Check visually the trunk grille for correct position. Tilt the back-seat rests back
to the standard position. Put the trunk cover into the trunk (Fig. 20).
22
Advertisement
