Electronic Avionics Set Up; Control Set-Up - Avios BushMule V2 Instruction Manual

4. Electronic avionics set up

1. The BushMule V2 ideally uses a 6 channel receiver as a minimum to get the best from the
model. Bind your chosen receiver to your transmitter, and plug in all the servos to the corre-
sponding channels.
2. These controls consists of the Throttle, Ailerons, Elevator, Rudder, Flaps and Cargo Door.
3. Plug your 4S LiPo flight battery into the XT-60 battery connector that powers up your BushMule
V2.
4. Check the rotation of the out-runner motors, they should both spin in opposite directions, and
both should rotate inwards towards the fuselage.
5. Check all your control services and make sure they are all operating the correct way without any
binding issues. Adjust mechanically the length of the servo push-rods to center all the control
surfaces.

5. Control Set-up

1. The Avios BushMule V2 handles extremely well, is very maneuverable through all ranges of the
flight envelope. In saying this, your Avios BushMule V2 needs setting up before your initial maiden
flight. After the first flight, then you can adjust the control surfaces to suit your own preferences.
8