Deda Elementi Jet Clip-On User Manual page 13

4.2 JET TWO
Fig. 3
1. Ensure the support plate (3b) to the spacers of the compatible handlebar
(see Fig. 3).
2. Position the extensions (1) on the support plates (3b) and use the fixing
plates (2b), relative screws and nuts (4b) to ensure them. The fixing plates
have double holes positions that allows to increase the width adjustment
range. Once the desired position of the extension (width and convergence)
has been established, tighten the screws to 6 Nm.
3. the carbon extension can be cut to length, never exceed the cut limit as
indicated on the product (see Fig. 4).
WARNING
The cutting of the carbon extension required specific tools and must be done by
an official Deda Elementi dealer or a qualified bicycle technician.
13