Standard & Low Front Seat Heights - Sunrise Medical Breezy 600 Series User Instruction Manual & Warranty

3. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed
by attendant, overcoming obstacles or
climbing curbs.
a. Press the rear anti-tip tube release lever.
b. Hold lever in and turn anti-tip tube up.
c. Release lever.
d. Repeat with second anti-tip tube.
e. Remember to return anti-tip tubes
to down position after completing
maneuver.
E. STANDARD & LOW FRONT
SEAT HEIGHTS
Note: Adjust seat height for body and mechanical
efficiency. Be aware that a change in seat height may
require a change in the size of the front caster
stems or forks.
1. If you raise the seat too high, you may "out-adjust"
the caster forks. If this occurs, the seat will tilt
toward the front and may cause the rider to fall.
2. To avoid this, you will need to use a longer caster
fork or fork stem.
1. Adjustment
a. For a standard 18 1/2" (470 mm) front
seat height:
1. Remove the axle bolt.
2. Set axle in the bottom frame setting.
Re-attach axle bolt and tighten.
3. Repeat steps on other side. Make
sure both sides are the same height.
b. For a low 17 1/2" (445 mm) front
seat height:
1. Remove the axle bolt.
2. Set axle in the top frame setting. Re-
attach axle bolt and tighten.
3. Repeat steps on other side. Make
sure both sides are the same height.
Note: Use a torque setting of 150 to 175 in./lbs.
(16.9-19.8 N . m) for axle nuts.
2. Seat Angle (not available on BREEZY 500)
If you change the seat height, make sure
you adjust the front casters to attain the
proper seat angle. (The seat should be
slightly higher at the front.)
930300 Rev. E
X . S E T U P & A D J U S T M E N T
32