A.
TO MOUNT & REMOVE REAR WHEELS
(QUICK RELEASE OPTION)
Note: Axle is not locked until:
a. The quick-release button pops out
fully. (Fig. A)
b. The ball bearings are fully visible on
the outside of the sleeve.
1. To Install Wheel:
a. Depress quick-release button (1) fully.
This will release tension on ball bear-
ings at other end.
b. Insert axle through hub of rear wheel.
c. Keep pressure on button (1) as you
slide axle (2) into axle sleeve (3).
d. Release button to lock axle in sleeve.
Adjust axle if it does not lock.
e. Repeat steps on other side.
2. To Remove Wheel:
a. Depress quick-release button (1) fully.
b. Remove wheel by sliding axle (2) out
of axle sleeve (3).
c. Repeat steps on other side.
I X . C H A I R B A S I C S
27
1. Quick-release button
Figure A
3
2
930300 Rev. E