Table of Contents
Advertisement
Subsystem Syntax
Comments
Example
Chapter 5
The
ABORt
command subsystem stops a scan in progress when the scan is enabled
via the interface and the trigger source is
TRIGger:SOURce HOLD
ABORt
•
ABORt Actions:
ABORt
(one scanning cycle per
1
continuous scanning cycles), and sets
internal triggering).
•
Stopping Scan Enabled Via Interface: When a scan is enabled via an interface,
an interface CLEAR command or the HP E1301A front panel "Reset Instr" or
"Clear Instr" keys can be used to stop the scan. When the scan is enabled via the
interface and
TRIG:SOUR BUS
E1301A front panel "Reset Instr" or "Clear Instr" keys to stop the scan.
•
Stopping Scan Enabled From Front Panel: When a scan is enabled from the
HP E1301A front panel, you can use
panel "Reset Instr" or "Clear Instr" keys to stop the scan.
•
Related Commands:
Stopping a Scan with ABORt
This example stops a (continuous) scan in progress.
TRIG:SOUR BUS
INIT:CONT ON
SCAN (@100:103)
INIT
.
.
ABOR
TRIGger:SOURce BUS
.
invalidates the current channel list and sets
command), sets
INITiate
TRIGger:SOURce IMMediate
or
HOLD
is set you can use
*RST
entered via the interface or the front
,
ARM
INITiate:CONTinuous
*TRG command is trigger source
Set continuous scanning
Scan channels 00-03
Start scan, close channel 00
Abort scan in progress
ABORt
or
ARM:COUNt
INITiate:CONTinuous OFF
(immediate
ABORt
or the HP
,
,
[ROUTe:]SCAN
TRIGger
C ommand Reference41
(no
Advertisement
Table of Contents
