Trigger; [:Immediate] - HP E1361A User Manual

Subsystem Syntax

[:IMMediate]

Comments
Example
Chapter 5
The

TRIGger

command subsystem controls the triggering operation of relay matrix
modules in a switchbox.
TRIGger
[:IMMediate]
:SOURce BUS | EXTernal | HOLD | IMMediate
:SOURce?
TRIGger[:IMMediate] causes a trigger event to occur when the defined trigger
source is
TRIGger:SOURce BUS
•
Executing the TRIGger[:IMMediate] Command: A channel list must be
defined with
[ROUTe:]SCAN <
command must be executed before
•
BUS or HOLD Source Remains: If selected, the
TRIGger:SOURce HOLD
with the TRIGger[:IMMediate]
•
Related Commands:
Advancing Scan Using TRIGger Command
This example uses the
TRIGger
switchbox from channel 00 through 03. Since
scan is advanced one channel each time
TRIG:SOUR HOLD
SCAN (@100:103)
INIT
loop statement
TRIG
increment loop
or
TRIGger:SOURce HOLD
channel_list and an
>
TRIGger[:IMMediate]
commands remain in effect after triggering a switchbox
command.
INITiate , [ROUTe:]SCAN
command to advance the scan of a single-module
TRIGger:SOURce HOLD
TRIGger
Sets trigger source to HOLD
Defines channel list
Begin scan, close channel 00
Start count loop
Advance scan to next channel
Increment loop count
TRIGger
.
INITiate[:IMMediate]
will execute.
TRIGger:SOURce BUS
is set, the
is executed.
C ommand Reference57
or