Parameters Programming; Access To Programming Menu - Sices GC250 Technical Manual

8
WARNING: Assigning an incorrect value to one or more parameters can
cause malfunctions, damage to things or injury to people. The parameters must
only be changed by qualified personnel. Parameters can be password protected
(refer to par. 8.5).
INFORMATION!
manufacturer, the installer or the final user to configure it in order to adapt it to specific system
requirements. This document does not contain the parameters list (even though many of them
are quoted in the description of the controller functions); the list is available in the documents
[1] where they're described in detail.
ATTENTION! S
modifiable only through the PC program SICES Board Programmer3.
BoardPrg3 is recommended as it simplify a lot the programming operations.
In this paragraph the general programming structure and the operating procedure to
read and/or modify parameters are described. You can use the device keyboard for this.
INFORMATION! The modification of some parameters can be
password protected (see par. 8.5)
INFORMATION!
possible with controller in OFF-RESET and engine idle.
8.1
The access to the programming modes of parameters can be done from any page only with
controller in OFF/RESET, keeping pressed at the same time digits STOP and AUTOfor at
least one second.
INFORMATION!
different function and cannot be used to modify the operation mode of the controller
and to control the engine.
To exit programming menu and to return to the main screen press the STOP.
At the beginning of the procedure, the main menu is always shown.
P.01
Main menu
1 System
2 Sequence
3 Protection
4 Aux. functions
5 Communication
7 Can_Bus
8 Plant
EAAM057608EN
The controller manages a high number of parameters that allow the
ome functions or particular configurations can be settable or
The programming by means of the device keyboard is only
When programming, digits STOP, AUTO and START have a
OFF .
1/06
The use of
GC250 Technical Manual 77