Getting Started; Setting Date & Time; To Cancel When Setting Up The Time; Change Current Date And Time - Microlife NC200 User Manual

3. Getting started

3.1. Setting date & time
1. After the new batteries are inserted, the year
will flash in the display. You can set the year by
pressing the M-button.
2. To confirm and then set the month, press the
MODE button.
3. Follow the previous instructions to set the
month, day, hours and minutes.
4. Once you have set the minutes and pressed the
START/IO button, the date and time are set and
the time is displayed.
• If no button is pressed for 20 seconds, the
device automatically switches to ready for
measuring.

To cancel when setting up the time:

• Press the START/IO button during time setup.
The LCD will show Date/Time icons with «—
:—».
• Then press the START/IO button to start a new
measurement.
• If no further action is taken within 30 seconds,
the device will automatically turn off.

Change current date and time:

• Press and hold the MODE button for approx. 8
seconds until the year number starts to flash.
Now you can enter the new values as
described above.

3.2. Sound settings

1. Press and hold the MODE button for 3 seconds
to set the sound.
2. Press the M-button to turn the sound on or off.
The sound is activated when the sound icon is
shown without a cross.
• When the sound setting has been chosen,
press the START/IO button to enter the «ready
for measuring» mode; otherwise the device will
automatically switch to ready for measuring
mode after 10 seconds.
12
body
measuring
mode
sound on
sound off
measuring
mode